Webinar Recording [VIDEO]: Process and Power Piping. Increase Productivity and Save your Time Twice with PASS/START-PROF
Agenda
•Supported codes for power and process piping •Integration capabilities •Object-oriented piping model creation principle •Piping object types: pipe, tees, bends, reducers, etc. •Equipment objects: Nozzle, Tank Nozzle, Pump, In-line Pump, Turbine, Compressor, Air cooler, Fired heater •Expansion joint objects •Databases, ASME B31J, Creep self-springing effect, wind, ice, snow, seismic loads •Minimum design metal temperature (MDMT) according to 323.2.2 (a)-(j) ASME B31.3 •Alternative occasional allowable stress 302.3.6 ASME B31.3 •Creep-Rupture usage factor, Appendix V ASME B31.3 •FRP/GRP/GRE piping analysis •Pipe and fittings wall thickness calculation •Operation mode editor. Load cases •Analysis reports: Stress in piping, Stress in insulation, Seismic stress, Flaw stress, Restraint loads, Equipment loads, Displacements, Expansion joints check, variable spring selection, constant spring selection, buckling analysis, flange leakage